Loctite? Lamp Assembly and Power Supply

Details

The Loctite? Lamp Assembly and Power Supply consists of a 6 inch Electrodeless “H” bulb and a state-of-the-art power supply. The lamp assembly has a rapid start and restart feature that eliminates a requirement for shutters and associated shutter mechanisms. The control board can be pulled out for easy service and component change. If any section of the UV curing system fails, a fault indicator array indicates the location of the failure. The output of the lamp is monitored to eliminate product scrap or loss. System can be selected for multiple power supply configurations so the master power supply can control others. Available in either 208 VAC or 240 VAC to match the electrical capabilities at the customer’s location.

 

Product Features

1.Electrodeless bulb technology provides high intensity output

2.This system is shipped standard with an “H” bulb, but will accept “D”, “V”, or “H+” bulbs to fine-tune the output

3.High UV output with low IR output results in less heat to the substrate

4.Rapid bulb change can be accomplished in minutes

5.Full cure width of 6 inches maintained throughout bulb life

6.Power Supply incorporates an on/off/standby control

7.Designed for use with the Loctite? Zeta? 7415 UV Benchtop Conveyor, item # 98003 (sold separately).

8.5,000 hours of expected UV bulb life of the “H” bulb with proper handling and maintenance.?